Carving / Emgraving Price
Posted: Mon Sep 19, 2011 6:41 am
Hi,
I tried out Bob's trivet (http://www.cncsharktalk.com/viewtopic.php?f=12&t=869) using the 1/8" ball nose (still haven't tried it on the 1/16") and I am happy with the result. (Thanks a lot Bob)
Pushing the idea to the marketing side:
1.) Are there any members here doing service for engraving and 3D design?
2.) How much do you usually charge as a standard price?
3.) Is the charge base on per square foot or per square inch?
4.) Is it service cost only or labor cost plus materials?
Thanks in advance.
I tried out Bob's trivet (http://www.cncsharktalk.com/viewtopic.php?f=12&t=869) using the 1/8" ball nose (still haven't tried it on the 1/16") and I am happy with the result. (Thanks a lot Bob)
Pushing the idea to the marketing side:
1.) Are there any members here doing service for engraving and 3D design?
2.) How much do you usually charge as a standard price?
3.) Is the charge base on per square foot or per square inch?
4.) Is it service cost only or labor cost plus materials?
Thanks in advance.