musclechuck

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

musclechuck

Post by gpeck »

Has anyone used a musclechuck on a bosch 1617EVS. The chuck that is on the router is not holding the bit
like it should anymore.

sk8nmike
Posts: 389
Joined: Thu Dec 01, 2011 7:35 am
Location: Carrollton, Tx

Re: musclechuck

Post by sk8nmike »

Check for debris in the chuck around the tightening screw and slot. I had one of these years ago and had unacceptable results from it. I switch to a collet system from PresiceBits, better hold, less runout and I get a better variety of bit shank sizes..

http://www.precisebits.com/gateways/Col ... m#paneTwo1

Post Reply