Spoil board

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

Post Reply
Jim N
Posts: 104
Joined: Fri Jul 30, 2010 3:45 pm

Spoil board

Post by Jim N »

Just a tip you may even know. I used dollar store foam board with double stick tape to cut out a 3.65" outside by 3.0 " inside ring out of 1/4" cast acrylic. No tabs and clean cut and didn't have to cut into my real spoil board. The acrylic was scrap from the dust shoe I made (but didn't use on this project) :roll:
Attachments
IMG_2184.JPG

Post Reply