CNCShark HD3 Randomly digs into wood - HELP!
Moderators: al wolford, sbk, Bob, Kayvon
Re: CNCShark HD3 Randomly digs into wood - HELP!
I had the same problem with the dust boot brushes being too stiff. Took a long while to figure out what the problem was. I received and installed the updated softer brush and the bristles were sucking into the dust hose connector so that isn't working. I replaced the brushes around the dust port inlet and left the other half with the soft brushes. It doesn't suck in the bristles but it was still too stiff. I cut half to the stiff bristles back and it helped but still not good enough. Wondering if the Kent dust boot is better?
Re: CNCShark HD3 Randomly digs into wood - HELP!
Regarding the dust boot problems, This thread has info regarding timing the bristles on an angle, so that they do not all hit at the same time.
http://www.cncsharktalk.com/viewtopic.p ... 86&p=23064
This lessens the gantry flex issue when using a dust boot.
Hope this helps
Bob
http://www.cncsharktalk.com/viewtopic.p ... 86&p=23064
This lessens the gantry flex issue when using a dust boot.
Hope this helps
Bob