I've been looking around and have not found anything on setting up the CncShark Pro with Mach3. I've seen people mentioning that there was a instruction sheet or something but damned if I can find it. I appreciate any and all help.
Thanks,
Ernie
CNC Shark Forum
The place to talk about, learn about, and even help teach others about the CNC Shark Routing System
[ Shop Rockler ]
Mach3 setup
Moderators: sbk, al wolford
2 posts
• Page 1 of 1
Re: Mach3 setup
by jeb2cav » Mon Apr 16, 2018 6:38 am
I think that the ability to connect with Mach was only present 'at the very beginning' with the original model of controller. I'm not aware of any ability for the Pro to be used directly with the Mach3 - at least in a supported by NWA fashion.
- jeb2cav
- Site Admin
- Posts: 1514
- Joined: Thu Sep 30, 2010 7:04 pm
- Location: Kentucky
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests