Shark Pro Plus HD Maintenance

Discussion about the CNC Shark Pro Plus HD

Moderators: sbk, al wolford

Shark Pro Plus HD Maintenance

Postby sharkcutup » Wed Apr 11, 2018 8:10 pm

After just a little over two years and only the Good Lord knows how many CNC Projects have been run on my machine It was time to re-surface the MDF spoilboard!!!
20180411_113327.jpg


So I setup my machine along with a dust boot (which I do not normally use cause MDF creates a lot of fine dust). Then created a .crv file in VCarve to re-surface the spoilboard.
Here is what the spoilboard looked like after the CNC machine re-surfaced the spoilboard. Removed .1" from spoilboard surface using a 1.25" diameter mortising router bit.
20180411_130817.jpg


I then cleaned everything to get any MDF dust off of CNC mechanics and gave the it a good lube!!!

Note: not sure why the photos are upside down here but they do come up correctly when clicked on --- strange!!!!

Sharkcutup
Let Those Chips Fly!!!
Shark HD3 Pro Plus Extended Bed with Spindle
Facebook: Hogan's CNC Crafts
sharkcutup
 
Posts: 299
Joined: Tue Mar 08, 2016 5:23 pm

Re: Shark Pro Plus HD Maintenance

Postby bill z » Thu Apr 12, 2018 8:28 pm

Yes, a good surfacing now and again helps in many ways. Yes it helps to create a flat surface again. If you use a large end mill, something like a 1 inch, it will show if your router or the z axis is out of adjustment. That is what I did and WOW did it need adjusting.

Yes, MDF is cheap enough to just replace but a saved buck always comes in handy.
User avatar
bill z
 
Posts: 271
Joined: Fri Sep 25, 2015 9:09 am
Location: Spring, Texas USA

Re: Shark Pro Plus HD Maintenance

Postby acebetter » Thu Aug 16, 2018 2:04 pm

I have cut an MDF spoilboard, used Rockler's 26099 t-slot bit to cut clamping slots (that bit worked really well). I mounted the board with 1/4-20 3/4" hex bolts. I made the board basically using this video as a guide https://www.youtube.com/watch?v=iyt8zOJUQJ4.

Now that I have it mounted I need to surface it. I am not sure what specs to use to create the tool in VCarve database. I plan on using Whiteside's 6220 sufacing bit for 1/32" depth of cut. Can someone help me with the tools specs?
thanx
acebetter
 
Posts: 8
Joined: Fri Jan 09, 2015 11:25 am


Return to CNC Shark Pro Plus HD

Who is online

Users browsing this forum: No registered users and 2 guests