power question ?

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: sbk, al wolford

power question ?

Postby Tenderfoot91 » Wed May 30, 2018 11:03 am

hello everyone ,
my name is Don and I just ordered the shark HD4.
My question is I noticed when I start my table saw the lights dim \ flicker a tad.
Will this mess up the CNC if it is running when I start that saw ?
Thank You
Tenderfoot91
 
Posts: 2
Joined: Sun May 13, 2018 10:17 am

Re: power question ?

Postby sharkcutup » Wed May 30, 2018 2:09 pm

I have the Shark Pro HD3 Extended bed machine in a 10' x 21' workshop with a Window A/C Unit. I have not had any problems when my A/C compressor kicks on during any of my CNC operations during the past two years. The A/C tends to flicker the lights but it has not had any interference with the CNC machine during a project carving. Lights, A/C and CNC are all on the same circuit breaker.

Sharkcutup
Shark HD3 Pro Plus Extended Bed with Spindle
Facebook: Hogan's CNC Crafts
sharkcutup
 
Posts: 300
Joined: Tue Mar 08, 2016 5:23 pm

Re: power question ?

Postby Tenderfoot91 » Wed May 30, 2018 4:58 pm

Thank You, I appreciate the information my friend .
Tenderfoot91
 
Posts: 2
Joined: Sun May 13, 2018 10:17 am


Return to Setting up the Shark

Who is online

Users browsing this forum: No registered users and 0 guests