Need help with accident!

Anything and everything CNC-Shark-related

Moderators: ddw, sbk, al wolford

Need help with accident!

Postby tankerzuke » Sat Sep 15, 2018 9:42 pm

Hope I haven't broke my machine! Was cutting a sign when I didn't notice my bit was headed for my hold down! I didn't get to it fast enough to stop the machine before it shut itself off and everything went dead!

I shut off the router then the power, tried to restart and nothing! Pushed and pulled on the emergency stop on the back, still nothing! Any suggestions?

Thanks
Zuke
tankerzuke
 
Posts: 6
Joined: Thu Nov 09, 2017 10:21 pm

Re: Need help with accident!

Postby sharkcutup » Sun Sep 16, 2018 8:30 am

Have you checked for a blown fuse? It is usually in the control panel box.

When I purchased my machine I purchased two fuses just in case. I have had my machine a little over three years now and have not needed to use them as of yet. Lucky I guess!!!

Sharkcutup
Shark HD3 Pro Plus Extended Bed with Spindle
Facebook: Hogan's CNC Crafts
sharkcutup
 
Posts: 299
Joined: Tue Mar 08, 2016 5:23 pm

Re: Need help with accident!

Postby tankerzuke » Sun Sep 16, 2018 1:45 pm

@sharkcutup yes that's what it was thank you! They weren't easy to find though lol! My buddy helped me and took a few minutes before he noticed they were in front lol! Maybe mark it ➡️fuse
tankerzuke
 
Posts: 6
Joined: Thu Nov 09, 2017 10:21 pm


Return to CNC Shark

Who is online

Users browsing this forum: No registered users and 4 guests

cron