Double Sided Sticky Tape Sheets

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: sbk, al wolford

Double Sided Sticky Tape Sheets

Postby tradewinds » Thu Oct 25, 2018 10:16 am

I have a few questions for those of you who use double sided sticky tape.
1. What brand do you use?
2. Where do you purchase it?
3. Have you ever had problems using this method on stock that is 1/8 thick?

Thank you.
tradewinds
 
Posts: 27
Joined: Wed Dec 16, 2015 6:41 pm
Location: St. Louis, Missouri

Re: Double Sided Sticky Tape Sheets

Postby basecircle » Sat Oct 27, 2018 8:47 pm

I use turners tape.Also double sided tape from the dollar store.On the 2in.foam I have used carpet tape.To remove the job from the machine on some of them thin pcs. shoot in some acetone .But not on plastics.A lite puddy knife helpa alot Hope this helps Basecircle
basecircle
 
Posts: 482
Joined: Fri Apr 08, 2011 2:14 pm

Re: Double Sided Sticky Tape Sheets

Postby Kayvon » Sun Nov 18, 2018 2:20 pm

I tried carpenter tape, but wasn't happy with the results, especially on 1/8" stock. Messy, hard to remove, too thick, and compresses a little when pressed.

I've since discovered the method of using (high quality) blue painter tape on both surfaces and superglue between them. Haven't looked back.
User avatar
Kayvon
 
Posts: 322
Joined: Tue Oct 21, 2014 11:46 pm


Return to Setting up the Shark

Who is online

Users browsing this forum: No registered users and 3 guests