Bit for 3D finish pass?

Anything and everything CNC-Shark-related

Moderators: ddw, sbk, al wolford

Bit for 3D finish pass?

Postby OCEdesigns » Fri Mar 08, 2019 9:12 am

I have done several of the 3D clip art that came with the software and some from the internet. So far I have used an 1/8th inch ball nose end mill for my finish pass. What does everyone use? I also have a 2 flute 7.5 degree V-Groove engrave bit with a 1/16" tip that I am wanting to try. This one >>> https://www.freudtools.com/products/70-103
Newbie with a Shark HD4 EB
OCEdesigns
 
Posts: 53
Joined: Fri Jan 11, 2019 8:26 am

Re: Bit for 3D finish pass?

Postby SteveM » Fri Mar 08, 2019 8:50 pm

You could use a 1/16" tapered ball nose or a 1/32".
SteveM
 
Posts: 160
Joined: Thu Sep 08, 2016 1:29 pm
Location: Franklin, Wisconsin

Re: Bit for 3D finish pass?

Postby OCEdesigns » Sat Mar 09, 2019 8:47 am

SteveM wrote:You could use a 1/16" tapered ball nose or a 1/32".



I just ordered a 1/16th ball nose also. Thanks!
Newbie with a Shark HD4 EB
OCEdesigns
 
Posts: 53
Joined: Fri Jan 11, 2019 8:26 am


Return to CNC Shark

Who is online

Users browsing this forum: No registered users and 3 guests