CNC Shark Forum

You have chosen an excellent topic. There has been a lot of valuable information posted about feeds and speeds on this forum. I would suggest doing a search with the words: feeds speeds. Just enter those two words in the upper right search box on this page. This will take you to a wealth of informat...

Skip45,
Thank you for the update. This information could prove to be very helpful for others with similar problems in the future.
Bob

Thank you for the update. My suggestions are based upon the experiences of many others who use this forum, so I wouldn't be too surprised if there's another solution.
Please keep us updated. Your experience will probably help others with similar challenges.
Bob

OK John, A couple things to check: 1. Check the tightness of the screws holding the coupler on the stepper motor to the Z drive screw. These become loose. Check also to make sure that the set screws on the coupler are engaged with the flat areas on the motor and the drive screw. 2. Check the coupler...

Frequently, when this happens it's because the laser post processor is being used for a routing project.
Check your PP and be sure you're not using the laser pp.
Bob

Try here:
https://www.kentcnc.net/nc
Bob

The good news: This is exactly what should happen when using the VCarve toolpath. You can control the depth if desired by setting the flat depth here: depth.jpg (Don't get confused by the start depth I'm using in this clip. Usually it's set a 0 inches.) Another note: Whenever you convert a bitmap to...

Bill,
Thanks for the feedback.
Have fun!
Bob

Bill,
Did you maneuver to this section? What was your clearance z set to?
Bob

Bill, The pp sounds right. Did you check the safe z height? If that checks out, it's time to call Next Wave for support: (419)491-4520 For assistance with your product or any questions, please email Tech Support at support@nextwaveautomation.com or call during regular business hours. Call before thi...