Search found 7 matches
- Tue Jul 30, 2013 2:52 pm
- Forum: CNC Shark Pro Plus HD
- Topic: questions from a newbie
- Replies: 2
- Views: 2383
questions from a newbie
hi, i am a student, and at our school we have a cnc machine, and i am the only one with half a clue how to use it and the software, (the last kid {graduated} ruined a bit and put a hole in the aluminum table top. we have very few bits also but back to the point, can i set a larger bit to cut out the...
- Tue Jul 30, 2013 2:46 pm
- Forum: Shark Pro Plus
- Topic: not turning on?!
- Replies: 3
- Views: 3965
Re: not turning on?!
forgot to reply, the power cord was shot, replaced power cord and ta-da
- Wed May 15, 2013 12:20 pm
- Forum: Software. Programming
- Topic: registration errors
- Replies: 1
- Views: 1546
Re: registration errors
nevermind, it suddenlty started working, very anoyyinfg when that stuff happens
- Wed May 15, 2013 12:10 pm
- Forum: Software. Programming
- Topic: registration errors
- Replies: 1
- Views: 1546
registration errors
tried to update control panel to most recent one and the program has told us we need to register, spo i entered in all info, then it says error, controler ID is 0, please help
- Wed Apr 10, 2013 11:06 am
- Forum: Shark Pro Plus
- Topic: not turning on?!
- Replies: 3
- Views: 3965
not turning on?!
the cnc machine is not turning on, is this a common issue, or did our not usiung a surge protector bite us in the butt?
- Wed Apr 03, 2013 11:11 am
- Forum: Software. Programming
- Topic: automatic round-overs?
- Replies: 6
- Views: 4442
Re: automatic round-overs?
ittt is rounded far to much for a 1/8 end mill i. e. 1/4 radius, and i would postt pictures but the shop was cleaned and it was thrown awaty, i will run another cut and try to have something up tomorrow, we have ordered a few finer bits, but 1/8 end-mill is the finestt we have rightt now , i will as...
- Tue Apr 02, 2013 11:23 am
- Forum: Software. Programming
- Topic: automatic round-overs?
- Replies: 6
- Views: 4442
automatic round-overs?
hi, i am a studentt at high school learning how to use the cnc machine(shark pro) and while tttrtying to make a insert with 3" verdana letters using vetric VCarve Pro 6.5 and on corners of the letters it would round over mor than the 1/8 endmill, when i asked about tttthis on vetrics forum they said...