Search found 3 matches
- Sun Sep 09, 2018 12:36 am
- Forum: CNC Shark
- Topic: Z-Axis adjustment
- Replies: 2
- Views: 2405
Z-Axis adjustment
My Black Diamond machine’s Z-Axis is not 90 degrees to my table. This has never bothered me making lithographs. Flattening my sacrificial board, I have pronounced lines on the X-Axis. My gantry is as it should be, but my router bracket is out of alignment and I can see no way to be able to adjust it...
- Wed Jan 01, 2014 4:03 pm
- Forum: Setting up the Shark
- Topic: Instructions
- Replies: 4
- Views: 3197
Instructions
I am extremely new and have trouble learning from reading instructions. All my life I have learned by being shown or stumbling around until I get it. Since this is an expensive machine and I do not wish to develop any bad habits, I wish to find out if there are any CNC Shark users in the 94534 area ...
- Wed Oct 16, 2013 9:08 am
- Forum: Setting up the Shark
- Topic: Black Diamond setup
- Replies: 3
- Views: 2738
Black Diamond setup
I just purchased the Black Diamond and none of the instructions say anything about the Diamond.
Am I to consider it the same as the Shark Pro during my initial start up?
Am I to consider it the same as the Shark Pro during my initial start up?