CNC Shark Forum

Thank you tony. I will look into the anti backlash couplings to see if there is any play there.

In cutting a 12" circle and cutting 10 slots to make a Mexican domino train board i have found that the domino slots differ by .06 from side to side. Is this the normal error in a Shark? The one I am using is a older one and only has a 20 x 12 cutting area but thought the error was only .01. If it i...

When I run a program but want to make a second copy the Shark seems to need to be Shut down each time. The jog and other functions are grayed out and will not allow access to them until I exit the program and we start the shark software. Doing this I need to zero out the unit each time. What am I do...

Sparkie113
New Hartford, Ct 06057

Thank you Brian
That was it
When I loaded v8.0 it also turned it off in v7.5 to so I could not complain settings.
Thanks again
Rich

I did check that but will run the program again tonight to verify that.
Thank You
Rich

I downloaded Vectric 8 and when i did my Shark would no longer same more that one tool path in the project.
It only sends the 1st tool path to the Shark.
to keep going i need to run the 1st tool path then delete it and move onto the next to complete the project.
Has anyone else had this problem?

This may help if it is a new machine.
When I started for the first time I found X & Y axis ok but Z was cutting a1/8 deep
Tech had me re flash the controller
If you need this file let me know and I will send it.
Rich

Thank You
I will also check to see if it is square.
Rich

I am new to CNC Shark but is it common to have to shim the base table in the "X" axis?
It is off about 1/16.
Thank you
Rich