CNC Shark Forum

I have an HD 3 and have hit the stops numerous times and have not had a parts failure.

Barry

You can also use an external disc drive that plugs in to a USB Port.
Barry Anderson

You can probably get one from Next Wave. They have always been very responsive when I had a need or problem.

Barry

I went by my local Shark vendor to check on the price of a new machine. A new HD 4 is $3999. When you add the water cooled spindle, the touch plate and the wiring harness, you're over $4900, before sales tax. This would be a great deal for someone wanting to get a CNC. If you desire additional infor...

When I added a similar bit, I just set it up as an 1 1/4" end mill. Might not be the best way but it works for me.

Shark HD -3 $3250 This machine has less than 50 hours on it. I jumped the gun and purchased it as a second machine in anticipation of a large project that did not materialize. It has: water cooled spindle, touch plate, anti-static wire harness purchased from Thom Randolph in Washington. Since I had ...

My HD 3 with water cooled spindle uses 110v. It is not on a dedicated circuit, although most times it is running, nothing else is used on the circuit. I do plug my computer into a surge protected battery backup.

Shark HD -3 $3250 This machine has less than 50 hours on it. I jumped the gun and purchased it as a second machine in anticipation of a large project that did not materialize. It has: water cooled spindle, touch plate, anti-static wire harness purchased from Thom Randolph in Washington. Since I had ...

It has been a couple of years so I can't remember I ordered it through my local woodworking tool/supply store.

Bill, when I do an inlay, I look at it as two parts, the female part, and then the male part that is inlayed into the female. I v carve cut the female to start at zero and have a flat depth of .02. I make the male a mirrored image. Draw a box around it and v carve it to start at 0.1 with a flat dept...