Search found 3 matches
- Sun Jun 05, 2022 11:11 pm
- Forum: Setting up the Shark
- Topic: Y-Axis Gone Wild
- Replies: 2
- Views: 6232
Re: Y-Axis Gone Wild
Next wave replaced both the controller and pendent, but still had issues. I realized I did not have any problems when I ran the Gcode file from the pendent, so I worked on eliminating anything that could be caused by my laptop. I masked off the mouse area built into the keyboard and then installed a...
- Sat Sep 18, 2021 6:06 pm
- Forum: Setting up the Shark
- Topic: Y-Axis Gone Wild
- Replies: 2
- Views: 6232
Y-Axis Gone Wild
I've just had my new Shark SD110 for a few weeks. It's taken more time than I thought to get up to speed, but I have created a Spoilboard, surfaced it, and have used Vcarve to design clamps. Up until now, anything that wasn't working as expected could be explained by something I wasn't doing, or doi...
- Sun Sep 05, 2021 8:48 pm
- Forum: Setting up the Shark
- Topic: Spoil board for Shark SD110
- Replies: 2
- Views: 3158
Spoil board for Shark SD110
Just setting up my new SD110. I’m stuck this weekend by a mismatch error when unlocking the Pendant. In the meantime, I thought I’d get started with a spoil board. I’ve watched several videos and understand width, length, how to fasten it to the base, and how to fasten the workpiece to the spoil boa...