Search found 2 matches
- Tue Feb 22, 2022 2:23 pm
- Forum: Software. Programming
- Topic: Tabs on a radius.
- Replies: 3
- Views: 2583
Re: Tabs on a radius.
While I have had that problem, it wasn't the case here. However, I have discovered some useful tips. Watching the mechanics of the gantry, I noticed that there are four points where either the x or y stepper motors will pause before beginning to rotate in the opposite direction to continue the radiu...
- Thu Feb 17, 2022 11:10 pm
- Forum: Software. Programming
- Topic: Tabs on a radius.
- Replies: 3
- Views: 2583
Tabs on a radius.
Hello all, I recently purchased a never before used Shark HD4 and the Vcarve pro software. I was running a bobcnc E4 with fusion 360. So, I am producing medallions out of 1/4 inch hard maple at 3.5 and 4.5 inch diameter. I am using a profile cut with tabs, 1/8 inch upcut endmill, 50 in/min at 20,000...