Search found 4 matches
- Sat Apr 27, 2024 2:04 pm
- Forum: Everything 4th Axis
- Topic: Tapered Work Piece Question
- Replies: 0
- Views: 11
Tapered Work Piece Question
Can the standard 4th axis (or the VCarve software) be set up to handle a work piece that tapers from larger to smaller diameter?
- Sun Apr 21, 2024 1:08 am
- Forum: Software. Programming
- Topic: Question on VCarve Post Processors for Shark HD510
- Replies: 1
- Views: 93
Question on VCarve Post Processors for Shark HD510
I have a Shark HD 510 and I'm using VCarve software. I'd like to make some changes to the Post Processors (I'm OK doing this - I actually wrote the motion control programs to cut Bausch & Lomb contact lenses on CNC lathes). My question is: Can anybody point me to documentation that I can read to und...
- Sun Apr 14, 2024 3:51 pm
- Forum: Everything 4th Axis
- Topic: All updated firmware but manual shows different setup
- Replies: 0
- Views: 204
All updated firmware but manual shows different setup
I have a standard 4th axis for an HD510. The controller card is installed (I know it's correct - I build PCs). I have updated both the controller box and the pendant firmware. However, when I go to run through the setup instructions, it shows to select the 4th axis from the "Apps" menu on the pendan...
- Mon Dec 05, 2022 2:45 pm
- Forum: CNC Shark
- Topic: Muscle Chuck for 2 hp spindle
- Replies: 1
- Views: 4008
Re: Muscle Chuck for 2 hp spindle
Hope this gets read as I know it's a bit late! You can add some silver coils to the water as well as silver is a natural antibiotic. You can buy coils of silver (pretty cheap - like $5-6) at NewEgg.com. I build water-cooled pc's and use it to keep the water in the tubes clean and it works like a cha...