CNC Shark Forum

mine does only 3/4 of the project

lsvien wrote:Additional shots of the handles.

great job

will do. already thinking of ways

I ordered one to try

A while back I needed to work on smaller parts that had been cut to finish size on the table saw/chop saw. Quite often that is way faster than profiling around a piece to cut it out of a board. I also needed to work on three sides. Tricky with clamps. I purchased a pair of drill press clamps from t...

I have a shark HD. The circle pocket is cut useing a .25 EM at 30 IPM and .09 depth and step over. The pocket measures 1.466 up & down, but 1.496 side to side. I have tried changing the pocket cut to offset, raster, climb, conv. it always cuts not round. Thanks in advance for any suggestions. Andy ...

e1r9i7c9 wrote:Look what i'am doing whit my HD1, Now I can do 38x54 Inch.

I did mine 25 x72 an gives me 58 or 60 inch length. did not widen it

tonydude wrote:This was done with a .125 tapered ball nose bit cutting .41 deep in a 1/2" acrylic. Took 2 hrs to carve.

Tony

nice job tony

The first thing to do is unplug then plug in the usb cable from the computer. That always works for me when I get that message. Bob unfortunately, I did this get a aluminum bracket an no more slippage. I replaced mine an 2 outher. holds router nice an tight. someone on the forum sells them for 55.00

BTW I am using a Dewalt 618 router and even though I have the tightening bolt cranked real hard the router still moves in the holder, not just sideways but up and down also. How can I take care of that. Considering some friction tape around the router body to build it up?? Like I said POS, as there...