Search found 8 matches
- Sun Mar 27, 2011 8:31 pm
- Forum: CNC Shark
- Topic: 4th axis preview date
- Replies: 109
- Views: 94650
Re: 4th axis preview date
Too would like the 4th axis
- Fri Mar 11, 2011 9:20 pm
- Forum: CNC Shark
- Topic: Z axis cuttin to deep mid job
- Replies: 2
- Views: 2244
Re: Z axis cuttin to deep mid job
Thanks a lot for the tips. Replacing the USB cable is easy so I'll try that first. Then I'll try the dry lube. Should do that anyway..
Thanks,
Chris
Thanks,
Chris
- Thu Mar 10, 2011 6:47 pm
- Forum: CNC Shark
- Topic: Z axis cuttin to deep mid job
- Replies: 2
- Views: 2244
Z axis cuttin to deep mid job
I just set up my pro plus. A couple of small jobs cut ok. Doing a 20" x 25" flat pocket it randomly started going like 1/4 inch too deep. So I scaled the job son to 10x10 and ran the tool path again and it did the same thing in a different place.
Any ideas?
Any ideas?
- Fri Mar 04, 2011 11:53 pm
- Forum: Shark Pro Plus
- Topic: Controller not recognized, Failure to Connect....1
- Replies: 3
- Views: 3278
Re: Controller not recognized, Failure to Connect....1
Thanks for the tips. I followed the installation steps by the book several times, uninstalling everything, rebooting and re installing several time. I'had read and tried everything on this forum and others. Until my son had me right click on the .exe files and change their properties to install as t...
- Thu Mar 03, 2011 8:23 pm
- Forum: Shark Pro Plus
- Topic: Controller not recognized, Failure to Connect....1
- Replies: 3
- Views: 3278
Controller not recognized, Failure to Connect....1
Failure to Connect...1 is the error I get when running the Firmware Update program. The USB device drivers ncPOD not installed properly. I'm running Vista on a Dell Inspiron 1525. Loaded .net 4.0 followed the directions the manual. The yellow light is flashing. Any help would be appreciated. Can't w...
- Sat Feb 26, 2011 11:46 pm
- Forum: CNC Shark
- Topic: Tell us where you're from map
- Replies: 617
- Views: 537117
Re: Show us where your from map
Macomb, MI 48042
- Thu Feb 10, 2011 10:27 pm
- Forum: CNC Shark
- Topic: Adding Project File Sharing Capability to the Forum
- Replies: 24
- Views: 15394
Re: Adding Project File Sharing Capability to the Forum
It would be absolutely helpful. Learning by example drastically cuts the learning curve. I'd be happy to share my files as well.
- Thu Jan 06, 2011 11:47 pm
- Forum: Shark Pro Plus
- Topic: CNC Shark Pro Plus Setup Notes-Compliments InstructionManual
- Replies: 3
- Views: 6390
Re: CNC Shark Pro Plus Setup Notes-Compliments InstructionMa
Great documentation... Thanks.