CNC Shark Forum

I recently upgraded from the Bosch Colt to a Water Cooled Spindle. I have 12 unopened packs of Brushes for the colt.
These are from E-Replacement Parts
Carbon-Brush Set
Part Number: 2610008121


They sell for $8.38 I will sell them for $5 plus shipping

If interested please let me know

Mark

Think and Tinker offers precision collets for the 611. They are available in 1/8" and 1/4".

tHEY ALSO HAVE EXCELLENT BITS!

I had an issue with the machine running a raster cut along the x axis. It would pause and the x-zero would reset then it would continue with an offset in the x axis. Not only was it wasting material, it was going beyond the limit of the x axis and putting stress on the motor. Luckily I was paying at...

Had the same issue. Machine paused then reset x zero to place it paused. I formatted disk and had same issue.

Going to try buying a new disk. 1GB disks are hard to find now!!

Anyone else having this issue?

Thanks for the post

I would love to have a 4th axis!! Any update?

I have had the last 3 lithos cut with an increase in Z depth after approximately 1/4 to 1/3 of the cut. I ran the last one over with the workpiece in a new location on the table and increased the height of the workpiece as well. It cut wit the same error in the same place on the litho. It is as if t...

The 'issues' I was referring to are the individual cuts that I should of removed along the edges (holes) and the dip/drop in cutting depth halfway through their faces. That was a different depth for about 1/2 inch across and then back to normal. Still looking into that one. I have had the drop in Z...