I seem to be a program cliché or I'm stupid! I have four holes that are supposed to 3" and when I run them on my router they come out 3.5". I have reloaded the program,redrawn the cartoon,remove the card shutdown the system , etc. What can I do to get this program to change to 3" the system show 3" but I get 3.5"
bubs
My CNC Shark Pro
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 229
- Joined: Sun Jan 29, 2012 8:01 pm
- Location: Central Ohio
Re: My CNC Shark Pro
Not sure what program you're running but it sounds like you're using a 1/4" end mill and cutting on the outside of the line, rather than the inside.
Del
"It's not what you take when you leave this world behind you, it's what you leave behind you when you go."
"It's not what you take when you leave this world behind you, it's what you leave behind you when you go."
Re: My CNC Shark Pro
using a 3/4" bit on the inside
Re: My CNC Shark Pro
Hi - can you post your project? Also, what post processor are you using?
Re: My CNC Shark Pro
I'm on the apple right now the shark is run on my dell in the basement and I'm going to bed. I'm using the inch on the post processor with a 3/4" router bit on the inside of four three inch holes. I've redrawn the piece and renamed it with no change?
bubs
bubs
Re: My CNC Shark Pro
How do you recover from an emergency stop ?
How does one erase the little card in the controller box ?
How does one erase the little card in the controller box ?
Re: My CNC Shark Pro
Fixed it thanks for the ideas.
bubs
out
bubs
out