New control updates, problem
Moderators: al wolford, sbk, Bob, Kayvon
New control updates, problem
After uploading the new software, I can not JOG slowly, like .001 at a time. Is this common or is something wrong?
Re: New control updates, problem
Not certian what you are refering to.
Are you saying that it is not slowing down at all on the slow button?
I would suggest you change the FRO to 50% that will allow you to run slower speed.
Are you saying that it is not slowing down at all on the slow button?
I would suggest you change the FRO to 50% that will allow you to run slower speed.
Re: New control updates, problem
Tim, In the jog mode. Before I updated the to the recent software I could jog at .001 at at time now it moves to fast, say that I'm try to return to Y0 or X0 before I could just tap the keypad lightly and move .001 at at time noe I cant move that slow. And if I try to get back to a o point it very difficult.
-
- Posts: 191
- Joined: Wed Aug 04, 2010 11:28 am
Re: New control updates, problem
Here's a link to a post that explains how you can slow down the jogging to a really slow rate:
http://cncsharktalk.com/viewtopic.php?f ... w+jog#p298
It should work for you. The other option you can use if you know the exact amount you want to move is to use the "Set" function.
Ed
http://cncsharktalk.com/viewtopic.php?f ... w+jog#p298
It should work for you. The other option you can use if you know the exact amount you want to move is to use the "Set" function.
Ed
Re: New control updates, problem
Thank you Ed. I will try that. I'll let you know.