Touch Plate Bug in Control Panel

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: sbk, al wolford

Touch Plate Bug in Control Panel

Postby 4DThinker » Thu Sep 27, 2012 3:16 pm

I've updated to 1.5.0.23d, and at least one bug remains to be fixed. While on the Jog tab, when choosing Detect Touch Plate, the normal outcome is that the bit will step slowly down until it touches the plate, then move up to allow removing the plate. When I have my jog speed set to Medium or Fast the bit won't (often) come back up after touching the plate. It'll just sit on top of the plate until I manually jog it up. This doesn't happen every time, but often enough to be annoying. I can get it to work reliably if I leave jog speed on slow or step before selecting Detect Touch Plate.

Something to fix in 23e, perhaps?

4D
4DThinker
 
Posts: 951
Joined: Wed Jun 27, 2012 9:00 am

Return to Software. Programming

Who is online

Users browsing this forum: No registered users and 1 guest