I am trying to reinstall my Shark software on a new laptop with windows 8.
When I launch VCarve 3.1, I get two error messages before the program launches fully:
Config File Unknown Statement found in file on line 26 of file C:\Program Files (x86)\VCarve Pro 3.1\PostP\CNCShark-USB_3dContour_inch.pp DIRECT_OUTPUT = "CNCShark/CNCShark_run.ini".
When I click OK, another error message pops up that says:
Config File Unknown Statement found in file on line 25 of file C:\Program Files (x86)\VCarve Pro 3.1\PostP\CNCShark-USB_NewArcs_inch.pp DIRECT_OUTPUT = "CNCShark/CNCShark_run.ini".
When I click OK again, VCarve seems to finish launching fine. I seem to be able to create and save a new project as normal. Next I launched the CNCShark Control Panel and tried to load the G Code. I get "ncpodcodecompiler.exe has stopped working". I tried to load G code from a project I created and ran successfully in the past, but I get the same error.
I can Jog the router fine, so I know the control panel is communicating. Any suggestions?
VCarve error at launch and G Code loading error
Moderators: al wolford, sbk, Bob, Kayvon