I am having problem getting 3D cut to work on my shark pro plus.
What type of post processor file should I use.
the Shark is not listed in the list?
thanks robert
problem with 3Dcut
Moderators: al wolford, sbk, Bob, Kayvon
Re: problem with 3Dcut
Hi Robert,
You can use the same postprocessor files for the Shark as you do for VCarve. The most current ones can be found at the Next Wave Automation site - http://www.nextwaveautomation.com/DownLoads.aspx. Be sure not to use the post processors for Photo VCarve.
Place them in a similar spot as the VCarve Pro, but for Cut 3D - typically c:\Program Files\Cut3D\PostP
You can use the same postprocessor files for the Shark as you do for VCarve. The most current ones can be found at the Next Wave Automation site - http://www.nextwaveautomation.com/DownLoads.aspx. Be sure not to use the post processors for Photo VCarve.
Place them in a similar spot as the VCarve Pro, but for Cut 3D - typically c:\Program Files\Cut3D\PostP
Re: problem with 3Dcut
Thanks for the info
I will try it Monday
robert
I will try it Monday
robert