Cut 3d

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
LAMEIII
Posts: 16
Joined: Mon Nov 15, 2010 7:14 pm

Cut 3d

Post by LAMEIII »

I see that VCarve Pro and Cut 3d comes with the Shark Pro Plus. Are both of these programs the ones put out by Vectric?
Top
jeb2cav
Site Admin
Posts: 1524
Joined: Thu Sep 30, 2010 7:04 pm
Location: Kentucky
Contact:
Contact jeb2cav

Re: Cut 3d

Post by jeb2cav »

Yes they are both made by Vectric. To get a quick idea of what each of these can and can't do compared to the other, there is a handy comparison chart on the Vectric site - http://www.vectric.com/WebSite/Vectric/ ... rision.htm.

I'd also recommend signing up or at least reading through the Vectric Forum for software use. Many questions you may have about the software and software workflow have already been asked and answered there. And, if not, a lot of folks who use Vectric software participate in the forum. http://www.vectric.com/forum/
Top
Post Reply

Return to “Software. Programming”