virtual screen problem

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: sbk, al wolford

virtual screen problem

Postby 2manytoyz » Sat Jun 07, 2014 5:45 pm

I just upgraded to the 1405-01 version of 2.0 and half my project is off the virtual screen and my y=0 location is on the center of the screen. I have three tool paths (a profile toolpath, a drill toolpath, and a quick engrave toolpath), the latter two are fine and in proportion and scaled to the screen but the top half of the profile toolpath is off the screen. The file was originally in metric and some toolpaths cut through the material. Some posts said that was a problem so I converted everything to inches and made sure nothing cut through the material and it didn't help. Also went in the CNC Shark 2.0 file and deleted the preferences ini file (as suggested by Joseph) and restarted everything to no avail. Any ideas?
2manytoyz
 
Posts: 3
Joined: Mon May 26, 2014 10:56 pm

Return to Software. Programming

Who is online

Users browsing this forum: No registered users and 1 guest