Page 1 of 1
Shark Controler Software?
Posted: Fri Feb 04, 2011 9:48 pm
by rapiddawg
Is there a way to stop the running G-code, shut the comptor down, come back in the morning and then restart at the same spot or a bit before the point it was stopped?
Keith
Re: Shark Controler Software?
Posted: Sat Feb 05, 2011 12:29 am
by tonydude
That is a good question. I also would like to know because I have a large file to cut and will take me 12 hrs cutting time. I hope Tim will see this and try to answer this question.
Re: Shark Controler Software?
Posted: Mon Feb 07, 2011 11:59 am
by Buc
Tried editing the g-code with an M00 and all they other code needed to perform a program stop and continue the machining operation with a short peck drilling TAP file I have. I could not get the g-code to load. Next I just tried inserting a simple M00, that would not load into the controlled program either. This would have worked on my old Fanuc control at work if I were not retired.
Tony, you are going to have to train Ms.Tony to be cross functional and multi-task for the longer cutting time projects.
Re: Shark Controler Software?
Posted: Mon Feb 07, 2011 1:55 pm
by tonydude
Hey Buc,
I like your answer about my wife. I think thats funny. I'll have to tell my wife this one when I see here.
Tony
Re: Shark Controler Software?
Posted: Thu Feb 10, 2011 9:34 pm
by rapiddawg
Tony, I have recently spoke to Tim, he has said that it is not possible with the current controller.