CNC Shark Forum

Has anyone upgraded too 8.5? Or had any problems with it ? I have a black diamond that for some reason the controller after turning on at the start of cutting a toolpath turned the router off
about midway of the toolpath and broke the bit because the bit was not turning. I shut down the comtroller and stated allover, I pluged the router into a wallplug and finished the tool path. I have used the toolpath before without any problem. Would like to have the router come on at the start and shut off at the end of the toolpath like it always has.. please help. thanks Gene

Makes me not what to go to 8.5

Have you tried that same file but cut air, not wood, so you would not destroy another bit, just to see if the router turns off at the same spot? I would be interested.

The router oes not ome on at all through the controller.