plunging Z depth

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: sbk, al wolford

plunging Z depth

Postby WEB » Tue Oct 02, 2018 5:10 pm

I have had my CNC Shark since 2013, I run V-Carve pro and using the CNCShark-USB 3D contour (inch) post processor.

The project I am working on is carving the standard 50-star union of the US Flag. I have done several of these in the past, but the last three I have started getting inconsistent results in the Z depth. As the router moves further away from the point of origin, the z depth increases, the latest I was carving is approximately 9" by 6 3/8".
The star nearest the point of origin is carving the proper depth of 1/16" but on the opposite side of the union the depth is ~ 1/4". As the depth increases, so does the width of the stars.

I have separate files for different size unions-the last two were different sizes and both are having this issue.

The router appears to be secured to the gantry and the table is not that far out of level. I contacted Vectric and they feel if the project preview is correct-everything is good with the software.

I am a hobbyist and have been able to avoid any issues thus far with the Shark.......any suggestions?

Bill in MI
WEB
 
Posts: 2
Joined: Mon Apr 20, 2015 7:57 am

Re: plunging Z depth

Postby tonydude » Wed Oct 03, 2018 7:01 am

pp.JPG
(11.25 KiB) Not downloaded yet
I never use the 3D contour post processor, that is for 3D work. Use the arcs inch one. I've been using ny shark since about 10 yrs. Make sure your not hitting your upper z limit. That is how you lose position.

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 9.518, photo vcarve, cnc mako shark extended bed, control panel 2.1
tonydude
 
Posts: 1514
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: plunging Z depth

Postby Kayvon » Wed Oct 03, 2018 11:13 am

Are you certain both your workpiece and spoilboard are completely flat with respect to your machine? One or both may need to be leveled again.
User avatar
Kayvon
 
Posts: 410
Joined: Tue Oct 21, 2014 11:46 pm

Re: plunging Z depth

Postby WEB » Thu Oct 04, 2018 7:43 pm

Tony;

Thanks for the help......that was my problem (wrong post processor). Up and running (accurately) again.

Bill

:D
WEB
 
Posts: 2
Joined: Mon Apr 20, 2015 7:57 am


Return to Software. Programming

Who is online

Users browsing this forum: No registered users and 1 guest