Supported G codes

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: sbk, al wolford

Supported G codes

Postby Efreyenhagen » Wed Apr 24, 2019 4:58 pm

Just received a FX and like it so far.

Does anyone know if there is a list of G codes supported by NWA for the FX?

What about manually entering a G code from the pendant or a computer, anyone know how this can be done?

I have a bit of experience with CNC programming, I do like the robustness of the FX based on the cost but an accustom to more flexibility than the pendant seems to provide.

any help will be greatly appreciated.

Posts: 1
Joined: Fri Apr 19, 2019 10:59 am

Return to Software. Programming

Who is online

Users browsing this forum: No registered users and 1 guest