New shark II user
Posted: Wed Jun 19, 2019 6:42 am
Hello
I have been trying to cut my first project with my new CNC. I made a file and took some monthly projects from online to start. I zeroed our everything at the top of material and bottom left or center. But I have not had anything work right. I watched different tutorials and set the post processing to cnc shark inches. Every time I turn it on, it starts st the right zero and then goes up way past the starting point and moves around in the air and then makes some basic straight lines in the wood every though the whole project is round.
I’m new to woodworking and spent a few grand on this in prep for a wedding and am getting so frustrated that I wasted my money and now have buyers remorse.
I have been trying to cut my first project with my new CNC. I made a file and took some monthly projects from online to start. I zeroed our everything at the top of material and bottom left or center. But I have not had anything work right. I watched different tutorials and set the post processing to cnc shark inches. Every time I turn it on, it starts st the right zero and then goes up way past the starting point and moves around in the air and then makes some basic straight lines in the wood every though the whole project is round.
I’m new to woodworking and spent a few grand on this in prep for a wedding and am getting so frustrated that I wasted my money and now have buyers remorse.