Ready2 control, HD4 extended thinks its a HD4

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
apt1011
Posts: 1
Joined: Mon Apr 01, 2019 5:59 pm

Ready2 control, HD4 extended thinks its a HD4

Post by apt1011 »

Hello , Ready 2 control thinks I have an HD4 , after sending the unit "home" the work area turns gray and only registers a work area of 24 x 24. I can freely move the gantry anywhere , but I cant run any file that extends past 24 in the Y, I get the message notification "can not run file, out side machine space" etc.
In the controller setting it read HD4, I don't see any options to change it to HD4 extended.

Any help would be greatly appreciated.
Thank you

tonydude
Posts: 1581
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: Ready2 control, HD4 extended thinks its a HD4

Post by tonydude »

Ready2Control_User's_Manual 2020.pdf
(4.65 MiB) Downloaded 255 times
Ready2Control_Users_Manual.pdf
(1.96 MiB) Downloaded 231 times
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.

Post Reply