Carving Through Work Piece
Posted: Wed Jun 23, 2021 3:14 pm
I've had two recent incidents where the router bit was forcibly carved through the work piece and driven into the aluminum table below. The router is forced into the work piece to the point where the collect is burning the wood. In the first incident the bit and collect jammed up so bad that the fuse blew in the controller. In today's incident the bit (¼) broke.
Had a fellow woodworker and accomplished CNC carver review the code
(Vectric – Vcarve PRO 10.5). The code was correct.
Any insight in this will be much appreciated.
Shark HD Limited Edition – Registration 30505-DZQC-3-1-CCAWCAXC-123-92D437CB
Thanks
Frank T Bye Sr 06/23/21
Had a fellow woodworker and accomplished CNC carver review the code
(Vectric – Vcarve PRO 10.5). The code was correct.
Any insight in this will be much appreciated.
Shark HD Limited Edition – Registration 30505-DZQC-3-1-CCAWCAXC-123-92D437CB
Thanks
Frank T Bye Sr 06/23/21