V-carved tool path truncated

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
NathanAu
Posts: 9
Joined: Sun Aug 25, 2019 10:32 am

V-carved tool path truncated

Post by NathanAu »

I am having a problem cutting V-Carved pockets for an inlay where the are odd deviations in the edges of the pocket so I decided to cut several 8-sided stars (compass rose) to see if it just happening in certain directions or if there was any other pattern I could spot. The only problem I found is that the sharp corners of the star is not going all the way to the end leaving round and truncated tips on the stars. I can actually see that is not going to the end of the cut in the CNC Shark control panel (v2.1). The green cross hairs that show the bit location moves out from the center of each star toward the end of the radial line but reverses directions before reaching the end of the line. When I measure the result of the resulting star between 2 opposite points of the star, it is definitely smaller than measured in Vectric Vcarve Pro (v11).


Here is the simulation in Vcarve Pro
Compass Roses.jpg
And the result that I am actually getting
IMG_3712.JPG
My first posting here so I hopefully I uploaded the photos correctly. I also attached the gcode for this cut.

My machine is an HD3 and up until now has performed pretty flawlessly so I am not sure exactly. Anyone have any ideas what is going wrong here?
Attachments
Stars V-bit.tap
This is the gcode for this cut.
(30.38 KiB) Downloaded 69 times

Post Reply