TouchPad quit in middle of the job

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Cryptoshop
Posts: 1
Joined: Sat May 14, 2022 12:56 pm

TouchPad quit in middle of the job

Post by Cryptoshop »

How can I restart job if the flash drive stopped reading, the TouchPad had to be restarted.

User avatar
Kayvon
Posts: 552
Joined: Tue Oct 21, 2014 11:46 pm

Re: TouchPad quit in middle of the job

Post by Kayvon »

There's no way to pick up where you left off. If you can reset the gantry to the exact starting position, you can rerun the entire job.

markjonesranger
Posts: 67
Joined: Mon Aug 17, 2020 3:47 pm
Location: Ozark Mo
Contact:

Re: TouchPad quit in middle of the job

Post by markjonesranger »

I found the pendant to be very sensitive to vacuum created static electricity. Keep that vacuum hose away from the controller and most of those issues will not be a problem.

Post Reply