Shark Pro HD & Fusion 360
Posted: Tue Feb 28, 2023 1:34 am
Hello
I've just a secondhand Shark Pro HD.
I'm new to CNC Routing, but not to Fusion or CNC in general.
Fusion doesn't have a machine setup for this CNC Router. I've used the generic 3 axis router. Is this ok? If so, what are the correct inputs?
I understand that there is a "post" file required to export into the correct gcode format?
Any assistance would be gratefully recieved.
Thanks
I've just a secondhand Shark Pro HD.
I'm new to CNC Routing, but not to Fusion or CNC in general.
Fusion doesn't have a machine setup for this CNC Router. I've used the generic 3 axis router. Is this ok? If so, what are the correct inputs?
I understand that there is a "post" file required to export into the correct gcode format?
Any assistance would be gratefully recieved.
Thanks