You have helped me so much in the past I thought you might be able to answer a couple of questions for me. I will be going out to my Shark Pro next week for the first time since last Sept and I think I have forgotten more than I knew.
I have the 1.4 version of the controller soft ware installed on my stock from the box Pro. I have downloaded the 1.7 version and the inch arc an inch for photo v carve and v carve 6. Do I and can I use these without upgrading anything else?
Also the Shark basic panel and the scan panel appear the same except for the scan part. Since I have the scan and probe is it necessary to have both installed or can I use the scan panel for both basic and scan?
Thanks for your help
Allen
Shark controller
Moderators: al wolford, sbk, Bob, Kayvon
Shark controller
Don't cry unless you broke the machine, just toss it in the "Blue Box" and start over!!