Updated Software and Post Processors

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Tim Owens
Posts: 361
Joined: Wed Jul 28, 2010 3:51 pm

Updated Software and Post Processors

Post by Tim Owens »

We have updated our controller software to version 1.4.0.15 this is providing support for Pro Plus users. The controller will automatically switch parameters depending on which controller it senses on power up.
We have also added new post processors that work with the Pro Plus and anyone that will get a future retrofit auto on/off ability otherwise there is no need to download them. These will be standard in the Vcarve Pro 6.0 that will be released later this year.

Thanks

Tim

rodgerst4
Posts: 2
Joined: Wed Aug 25, 2010 11:26 am

Re: Updated Software and Post Processors

Post by rodgerst4 »

I was using Cut3D and noticed there were no post processors for the shark pro. How do I get the post processor and how is it installed.

Thanks

Tim Owens
Posts: 361
Joined: Wed Jul 28, 2010 3:51 pm

Re: Updated Software and Post Processors

Post by Tim Owens »

Actually Vectric uses the same post processor for Vcarve,Cut 3d and Aspire. The only difference is photocarve does not use Arcs so it has a differnt post processor. You can copy the Vcarve post processor to the Cut 3d postp folder.

Post Reply