CNC Shark Forum

I wrote the programs and Woodworker's Journal's Rob Johnstone did the video. You can download the files for free!

http://www.woodworkersjournal.com/resou ... index.html

Enjoy!

Ralph

Thanks again, Ralph!

I had it downloaded and have been looking through my scrap pile for something to cut one out from within 5 minutes of getting their email. Already ordered some marbles. Thinking about gluing up some beech to make one from. I've got a sister nearby that has at least 5 grandkids so far, and she is always looking for something like this to distract them when they are over. She'll have to keep it away from the toddlers though. Those marbles look too much like candy. I may have swallowed a few when I was a kid come to think of it.

Thank you for the files Ralph.
Bob

Thanks Ralph. Your always a helping hand around here. Thanks a lot.

Tony

Thanks Ralph I will give it a shot Basecircle