Page 1 of 1

Wooden Cross Puzzle

PostPosted: Wed Dec 23, 2015 3:19 pm
by Stoelle
After seeing a number of wooden puzzles at a kiosk in our local mall, I thought I would try my hand in building a "simple wooden cross" puzzle. I used 3/4 inch stock to create this one, but it could be made at a number of different dimensions with modification. The puzzle consists of six pieces, each three inches long. I used a 1/8 inch end mill bit to cut out the pieces and the side cuts needed to be squared with a chisel or band saw in order for the pieces to fit snugly. After a little sanding and some wood wax, the pieces seem to fit fairly well.

You can search the internet for a solution to the puzzle using the search terms "simple wooden cross puzzle".

Using VCarvePRO 8.0 and a CNC Shark Black Diamond ....
Puzzle solved.JPG
Solved puzzle

Cut out.JPG
Cut out pieces with tabs on ends

Wooden Cross Puzzle.crv
VCarve 8.0 project file
(266.5 KiB) Downloaded 374 times

Re: Wooden Cross Puzzle

PostPosted: Wed Dec 23, 2015 7:56 pm
by Bob
Thank you Stoelle,
I will enjoy tormenting my friends. :twisted:

Re: Wooden Cross Puzzle

PostPosted: Thu Dec 24, 2015 5:55 pm
by Stoelle
Here's a link to a site that shows a solution to the puzzle: