I just bought my CNC Shark Pro Plus HD. It seems that everything was installed and working fine until I got to the part where I load the square-1in.tap file. When I do this, I get a load error warning message.
Does anyone have a clue as to what is going on here?
Thanks in advance.
Jerry
Load error
Moderators: al wolford, sbk, Bob, Kayvon
Re: Load error
Hi Jerry,
Did you get this resolved? If so, what was the solution? If not, can you send a screen grab of the error you are seeing?
Did you get this resolved? If so, what was the solution? If not, can you send a screen grab of the error you are seeing?
Re: Load error
This can be because of a bad usb port a bad usb cable usually.
it can also be a issue with a sd micro card in the controller (but that is rare).
it can also be a issue with a sd micro card in the controller (but that is rare).
-
- Posts: 5
- Joined: Tue Oct 09, 2012 6:05 pm
Re: Load error
I resolved this problem by contacting Next Wave directly. After trying a few different things with no success it was determined that I had a bad software download. I uninstalled, re-downloaded, and re-installed everything and that fixed the problem.