Grooves

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Butcherman
Posts: 10
Joined: Sat Jan 12, 2013 2:05 pm

Grooves

Post by Butcherman »

I need help removing grooves during the finishing tool path. The grooves run in the direction of the tool path. Not sure where to adjust to remove.
Top
BillK
Posts: 885
Joined: Mon Apr 18, 2011 3:08 am

Re: Grooves

Post by BillK »

Sounds like you need to adjust your stepover percent. Please read the following post, it should help you.
http://www.cncsharktalk.com/viewtopic.php?f=4&t=1672
BillK
http://www.Facebook.com/CarvingsbyKurtz
Instagram: carvingsbykurtz
Twitter: @CBKwoodcarver
Top
Post Reply

Return to “CNC Shark Pro Plus HD”