Bits for carving in foamed pvc(palight)
Moderators: al wolford, sbk, Bob, Kayvon
Bits for carving in foamed pvc(palight)
I want to experiment with some 1/2 inch foamed pvc. I would welcome any suggestions on bits to use 0 flits?,1,2? V bits?
Re: Bits for carving in foamed pvc(palight)
I carve Pink Foam insulation board all the time using regular bits with good results, just be sure they are sharp. Four flutes should give you a better finish as they take of less material per cut then 2 fluted bits at the same feed rate.