need help carving on a gun stock

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Alexschultz1
Posts: 6
Joined: Thu Jan 02, 2014 9:10 pm

need help carving on a gun stock

Post by Alexschultz1 »

I'm still new to this machine so any advice will help. The problem I'm having is figuring out how to carve on an irregular curved surface. The gun stock has a curve which I need to follow in order to wrap an engraving around. Do I have to build the stock in vcarve and then put the design on that? Can I set multiple 0 coordinates and have that rendered into v carve so I can use the router to draw the gun?

Post Reply