Problem with scan probe
Posted: Sun Feb 22, 2015 4:13 pm
I have question:
Is the touch probe temperature sensitive? It seems the probe hangs up off of the surface ( hi limits) for sometime while doing and X axis which is the longest scan (21 inches). Any ideas as to why or what I can do to correct. The size of the scan is X = 21" x Y = 9" . Should I reverse axis?
To clear this hangup I push up on the probe and it starts measuring the surface of the item again till it hangs up again. For sure it will not cover the item on the long run, like in to the night.
Having a problem getting a good clean scan.
Is the touch probe temperature sensitive? It seems the probe hangs up off of the surface ( hi limits) for sometime while doing and X axis which is the longest scan (21 inches). Any ideas as to why or what I can do to correct. The size of the scan is X = 21" x Y = 9" . Should I reverse axis?
To clear this hangup I push up on the probe and it starts measuring the surface of the item again till it hangs up again. For sure it will not cover the item on the long run, like in to the night.
Having a problem getting a good clean scan.