X and Y Axis

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon

User avatar
Bob
Posts: 1252
Joined: Sun Aug 08, 2010 3:35 pm

Re: X and Y Axis

Post by Bob »

There have been posts about the magical code: 787
Go here to unlock the potential.
Bob
https://www.cncsharktalk.com/search.php?keywords=787
Last edited by Bob on Tue Oct 29, 2019 10:09 pm, edited 1 time in total.
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)

User avatar
Kayvon
Posts: 552
Joined: Tue Oct 21, 2014 11:46 pm

Re: X and Y Axis

Post by Kayvon »

sharkcutup wrote:Oh yes rotating design before creating toolpaths Would solve his Problem IF he had left the cables alone in the first place!!!
My mistake. I was looking at his second post (after messing with cables).

I agree. I just leave Y as the long axis and rotate my jobs to fit.

sharkcutup
Posts: 408
Joined: Tue Mar 08, 2016 5:23 pm

Re: X and Y Axis

Post by sharkcutup »

The Two Major Reasons not to mess with the machine is

1.) machine may be in warranty and messing around with it may VOID said warranty.
2.) it could very well cause more problems than it could solve

Sharkcutup
V-Carve Pro Tips, Gadget Tips & Videos
YouTube Channel - Sharkcutup CNC
V-Carve Pro 11.554

User avatar
Kayvon
Posts: 552
Joined: Tue Oct 21, 2014 11:46 pm

Re: X and Y Axis

Post by Kayvon »

You'll note that was my first suggestion as the first reply from 8 months ago.
Kayvon wrote:1) You can change the dimensions in software so that X is 16" and Y is 36". This is what I do. It may require rotating your design to fit in the corrected dimensions.

Post Reply