Page 1 of 1
Version 10.5 and now a pause when starting
Posted: Fri Jul 24, 2020 8:35 am
by OCEdesigns
I have been away from the CNC for about 2 month's. Finally got back into it a little yesterday and noticed there was an update to version 10.5 so I did the update. I opened up a design I have run many times before to make another one. After double checking the design and nothing had changed, I save it on the USB and went to the pendant to start the carving. There are 3 different tool changes. Every time I hit the Start, the spindle raises to the safe height and then pauses for about 7 seconds before moving to the starting point. Not sure if this is a glitch or a new safety feature?
Re: Version 10.5 and now a pause when starting
Posted: Fri Jul 24, 2020 4:51 pm
by OCEdesigns
UPDATE:
In case anyone else is looking, this is not a glitch! They did do this as a type of safety feature.
Re: Version 10.5 and now a pause when starting
Posted: Mon Jul 27, 2020 3:52 pm
by Kayvon
If it bothers you, it sounds like the sort of thing that's contained in the pre-processing file. It would be easy enough to remove if you're interested.
Re: Version 10.5 and now a pause when starting
Posted: Wed Jul 29, 2020 3:39 pm
by OCEdesigns
Kayvon wrote: ↑Mon Jul 27, 2020 3:52 pm
If it bothers you, it sounds like the sort of thing that's contained in the pre-processing file. It would be easy enough to remove if you're interested.
I'm sure I can remove it but honestly it doesn't bother me. Actually gives me a second to make sure I didn't mess things up! LOL