Controller Router Relay

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon, al wolford, sbk, Bob, Kayvon

Post Reply
markjonesranger
Posts: 17
Joined: Mon Aug 17, 2020 3:47 pm

Controller Router Relay

Post by markjonesranger »

Bill Zaffos refered me to this part online. It cost about 17.00 and the two cords and spade tip connectors about 24.00 a couple of wire nuts and a CNC Box gadget box I have a Controller Router Activate Contactor box that turns my router on when the Controller says to do so. I blew a few fuses in the Power Supply cord going into my Shark Controller when I was using a Surfacing bit, or the router bit got wedged up. This Contactor relay will power the router so I won't blow the fuses in the Shark Box. Cost was right at 50.00 for all the parts.

Works very well. Here is a short video on the part. I will mount it permanent after some time goes by.
https://www.youtube.com/watch?v=GEi3c1ljHjw

Post Reply